Note : In the event that these conditions cannot be met (i.e. co-location with another
transmitter), then the FCC authorization is no longer valid, and the corresponding FCC ID may
not be used on the final product. Under these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC authorization.
6.5 OEM PRODUCT LABELING
The final end product must be labeled in a visible area with the following text:
“Contains TX FCC ID: SX9UHF1B”
6.6 RF EXPOSURE
In order to comply with FCC RF exposure requirements, the antenna used for this transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
6.7 ADDITIONAL INFORMATION FOR OEM INTEGRATORS
The end user should NOT be provided with any instructions on how to remove or install the
DLP-RFID-UHF1B. This device is pre-certified to operate with the antenna models listed below:
?
DLP Design Near-Field Magnetic Loop Antenna
7.0 DISCLAMER
Neither the whole nor any part of the information contained herein nor the product described in
this datasheet may be adapted or reproduced in any material or electronic form without the prior
written consent of the copyright holder.
This product and its documentation are supplied on an as-is basis, and no warranty as to their
suitability for any particular purpose is either made or implied. DLP Design will not accept any
claim for damages whatsoever arising as a result of the use or failure of this product. Your
statutory rights are not affected.
This product or any variant of it is not intended for use in any medical appliance, device or
system in which the failure of the product might reasonably be expected to result in personal
injury.
This document provides preliminary information that may be subject to change without notice.
Rev 1.0 (November 2009)
5
? DLP Design, Inc.